Mech Sure Sweden AB

The LEMAG LUBEmag system is designed to measure the specific cylinder oil consumption of 2-stroke engines in combination with the LEMAG Shaftpower system. This can reduce wear of engine components caused by either under or overlubrication and can also show potential cost savings by avoiding any excessive consumption of cylinder liner lube oil.

One of the major design targets was to avoid any increase of the pipe resistance. The LEMAG LUBEmag system is suitable for all gravity driven lub oil supply systems even with low installation heights.

The system consists of two stainless steel tanks, which are filled and discharged automatically, alternating via two 2/3-way valves. Both tanks are aerated and protected against overfilling .

The time the system takes to discharge the measuring tanks is the basis for the calculation of the actual cylinder oil consumption. The level of the cylinder oil inside the measuring tanks is controlled by level switches. Their signals are transferred to an electronic controller, which in turn communicates with the LEMAG Shaftpower system. The consumption values are then indicated on the SHAFTPOWER touch-screen display.

In case of a "black out", the 2/3 way valves will directly connect the cylinder oil pipe without any measuring cycle . The LEMAG LUBEmag system is also equipped with a manual bypass pipe with an integrated 2-way ball valve is included, herewith fulfilling all classification requirements.

The solution for tug boats:
Monitor, reduce and save fuel costs!Monitor, reduce and save fuel costs!

CONTOIL® Fuel Monitor T (CFM-T) is able to display the consumption of up to 8 consumers
(e.g. 3 M/E and 5 A/E)

CONTOIL Fuel Monitor S helps owners and operators to save fuel and money on all vessel types using heavy fuel oil (HFO) or marine diesel oil (MDO), as we make fuel consumption transparent!

Fuel oil meters with threaded or flanged connection. Electronic counter with display of total volume, subtotal volume (can be reset) in m3, litres or US gallons. Flow rate per minute or hour and operation hours. Transmitter with 2 configurable signal outputs for volumetric pulses, flow rate (current or frequency) or limit switch.

Oil meters with mechanical roller counter. Versions with threaded or flanged connections as well as reed switch RV or inductive pulser IN (NAMUR IEC 60947-5-6).